Semi-trunk routing
This capability allows the user to create a Sketch plan that will only be routed on one end of the plan. By choosing the new command, Route Semi-Trunk, the Sketch plan will be optimized for the end opposite the Route to Dot, and then routed.
This can help the user to pre-route interfaces that may still require placement or pin and gate swapping optimization. To complete optimization of an FPGA or ASIC, and insure the placement of the interface is complete, the user can easily Reverse the Sketch plan to optimize the other end.
Learn more on Design Automation.
Related resources
Simcenter 3D for thermal multiphysics simulation
Simcenter 3D software is a complete solution for modeling nonlinear and transient heat transfer phenomena. Download this solution guide to learn how you can gain thermal multiphysics performance insight into your product.
Using simulation to enable faster and better transmission design choices
Hyundai Mobis uses Simcenter and HEEDS to eliminate physical prototypes in the design phase
Master the precision of the perfect part
Deliver greater operational efficiencies and better shop floor management with Digital Part Production solutions. Find out how you can automate production processes, boost part quality and reduce time to market.